[FFmpeg-user] Change the parameters of ffserver.conf file from command line

[mahek delawala]

Please reply as early as possible to my above query.

Regards,
Mahek

On 14 June 2018 at 10:58, mahek delawala <m.delawala95 at gmail.com> wrote:

> Hello All,
>
> Following is the content of my ffserver.conf file.
>
> HTTPPort 1234
> RTSPPort 1235
>
> # Number of simultaneous requests that can be handled. Since FFServer
> # is very fast, it is more likely that you will want to leave this high
> # and use MaxBandwidth, below.
> MaxClients 1000
>
> # This the maximum amount of kbit/sec that you are prepared to
> # consume when streaming to clients.
> MaxBandwidth 1000
>
> <Stream test1.mp4>
>     File "/home/mahek/Downloads/Panasonic.mp4"
>     Format rtp
>     Noaudio
>     VideoCodec libx264
>     VideoFrameRate 25
>     VideoBitRate 1000
>     VideoSize 480x272
>     AVOptionVideo flags +global_header
>     AVOptionVideo me_range 16
>     AVOptionVideo qdiff 4
>     AVOptionVideo qmin 10
>     AVOptionVideo qmax 51
>
>     AudioCodec aac
>     AudioBitRate 30
>     AudioChannels 2
>     AudioSampleRate 22050
>     AVOptionAudio flags +global_header
>     ACL allow 192.168.201.0 192.168.255.255
> </Stream>
>
> I want to change the File present in the conf file directly from the
> command line without doing editing inside the conf file. Is there any
> command through which I can change the parameter of conf file directly from
> the command line using some command ?
>
> Thanks in advance.
>
> Regards,
> Mahek
>
>