[FFmpeg-user] FFmpeg: how to output over HTTP

andrei ka andrei.k.gml at gmail.com
Wed Mar 20 17:19:07 EET 2019

remarque: ppl who send ismv via http to unified streaming servers
(apache/nginx) just put http url as output, it works.

On Wed, Mar 20, 2019 at 1:20 PM Ted Park <kumowoon1025 at gmail.com> wrote:

> > In my trace which I had analyzed as a proof of concept, HTTP was
> > perfectly recognized. I had used port 8888, while my Wireshark's HTTP
> > protocol seems to be configured to
> > "80,3128,3132,5985,8080,8088,11371,1900,2869,2710". So Wireshark should
> > be smart enough...
> You must be right, the only thing I can think of is if the capture was
> started after ffmpeg was run and only the chunked content was captured that
> can’t be decoded without the headers.
> >> The more important question is if there is an issue: Segmentation Fault
> 11
> >
> > This is not an issue. I can segment the mpegts chunks just fine. This
> error
> > is coming due to the nature of how I am running my server side `-f null
> -`
> > to output null to stdin (not how I would normally) for the sole purpose
> of
> > testing network transport.
> You misunderstand, the message isn’t regarding segmenting the stream, it
> might indicate an issue within ffmpeg itself
> _______________________________________________
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> https://ffmpeg.org/mailman/listinfo/ffmpeg-user
> To unsubscribe, visit link above, or email
> ffmpeg-user-request at ffmpeg.org with subject "unsubscribe".

More information about the ffmpeg-user mailing list