[FFserver-user] Streaming through ffserver
bclark at spectraaccess.com
Fri Oct 7 13:39:13 CEST 2011
I use the following in ffserver.conf
# Bitrate for the audio stream. Codecs usually support only a few
# different bitrates.
# Number of audio channels: 1 = mono, 2 = stereo
# Sampling frequency for audio. When using low bitrates, you should
# lower this frequency to 22050 or 11025. The supported frequencies
# depend on the selected audio codec.
And my ffmpeg command line is:
ffmpeg -s 400x320 -f video4linux2 -vc 1 -i /dev/video0 -f alsa -ac 2
-i hw:0,0 -acodec libmp3lame -ab 32k http://127.0.0.1:8090/feed1.ffm
On 10/07/2011 04:33 AM, Ioannis Maistros wrote:
> Hello Amar and thanks for your quick reply
> I tried codec mpeg and still do not have motion in VLC, I only get a
> picture and some times some motion for some seconds.
> What would be the appropriate settings in the ffserver.conf or do I
> have to leave them as it is?
> Thanks again
> Date: Fri, 7 Oct 2011 12:37:41 +0530
> From: nandan.amar at gmail.com
> To: ffserver-user at ffmpeg.org
> Subject: Re: [FFserver-user] Streaming through ffserver
> Dear Ioannis Maistros,
> Mjpeg or jpeg is very poor compression format for video.
> Please try codedc like mpeg or h264 for encoding.
> ffmpeg -i
> -vcodec mpeg or h264 "http://192.168.1.118:8090/feed1.ffm"
> 2011/10/7 Ioannis Maistros <patrida at hotmail.com
> <mailto:patrida at hotmail.com>>
> Hello FFMpeg users.
> I am new in FFMpeg user forum and I would like to ask your help in
> the following issue.
> I would like to stream from an Axis camera(mjpeg format) through
> FFmpeg to the FFserver and watch the stream from another machine
> by using VLC.
> I have tried a lot of combinations in the ffserver.conf file and
> ffmpeg commands line but without any luck.
> The only I get is an image jpeg(without any motion) in the other
> end through VLC.
> My last attempt was the default ffserver configuration file and an
> extra option of AVOptions flags +global_header(because ffserver
> was complaint about global headers all the time) and the ffmpeg
> command line was like the following one:
> ffmpeg -i
> -vcodec copy "http://192.168.1.118:8090/feed1.ffm"
> Any help will be appreciated.
> Thanks in advance
> Best Regards
> ffserver-user mailing list
> ffserver-user at ffmpeg.org <mailto:ffserver-user at ffmpeg.org>
> Amar Kumar Nandan
> Karnataka, India, 560100
> ✉:nandan.amar at gmail.com <mailto:nandan.amar at gmail.com>
> _______________________________________________ ffserver-user mailing
> list ffserver-user at ffmpeg.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the ffserver-user