[FFmpeg-user] Change the parameters of ffserver.conf file from command line

[mahek delawala]

Hello All,

Following is the content of my ffserver.conf file.

HTTPPort 1234
RTSPPort 1235

# Number of simultaneous requests that can be handled. Since FFServer
# is very fast, it is more likely that you will want to leave this high
# and use MaxBandwidth, below.
MaxClients 1000

# This the maximum amount of kbit/sec that you are prepared to
# consume when streaming to clients.
MaxBandwidth 1000

<Stream test1.mp4>
    File "/home/mahek/Downloads/Panasonic.mp4"
    Format rtp
    Noaudio
    VideoCodec libx264
    VideoFrameRate 25
    VideoBitRate 1000
    VideoSize 480x272
    AVOptionVideo flags +global_header
    AVOptionVideo me_range 16
    AVOptionVideo qdiff 4
    AVOptionVideo qmin 10
    AVOptionVideo qmax 51

    AudioCodec aac
    AudioBitRate 30
    AudioChannels 2
    AudioSampleRate 22050
    AVOptionAudio flags +global_header
    ACL allow 192.168.201.0 192.168.255.255
</Stream>

I want to change the File present in the conf file directly from the
command line without doing editing inside the conf file. Is there any
command through which I can change the parameter of conf file directly from
the command line using some command ?

Thanks in advance.

Regards,
Mahek